TM 9-2320-302-34
0031 00-1
CRANKSHAFT FRONT OIL SEAL REPLACEMENT
0031 00
THIS WORK PACKAGE COVERS
Removal, Inspection, Installation
INITIAL SETUP
Maintenance Level
Direct Support
Tools and Special Tools
Tool kit, general mechanic’s (Item 132, WP 0126 00)
Inserter, seal (Item 50, WP 0126 00)
Remover, seal (Item 101, WP 0126 00)
Materials/Parts
Seal (P/N 23518355)
Cloth, abrasive (Item 9, WP 0125 00)
Oil, lubricating (Item 25, WP 0125 00)
Equipment Condition
Vibration damper removed (WP 0020 00)
REMOVAL
1.
Install seal remover (1) over end of crankshaft and against gear case cover (2). Install six self-tapping screws (3).
2.
Install three bolts (4) in seal remover (1) until bolts contact gear case cover (2).
NOTE
If self-tapping screws strip out of seal case, remove six self-tapping screws and three bolts. Rotate seal
remover one-half distance between existing screw holes in seal case and repeat steps 1 and 2.
3.
Work clockwise and turn three bolts (4), one at a time, one full turn until oil seal is removed. Discard oil seal.
4
3
2
1
