TM 9-2320-302-34
0014 00-4
AIR INTAKE MANIFOLD REPLACEMENT - CONTINUED
0014 00
INSTALLATION - CONTINUED
4.
Install one long bolt (14) in lower center position of air intake manifold (4) and hand tighten.
5.
Remove six guide studs.
6.
Install remaining four long bolts (14) in air intake manifold (4). Tighten by hand.
7.
Install two short bolts (15) at ends of air intake manifold (4). Tighten by hand.
8.
Tighten seven bolts (14 and 15) to 43-54 lb-ft (58-73 Nm), in sequence shown.
WARNING
Adhesives and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin and
clothing. To avoid injury or death, keep away from open fire and use in a well-ventilated area. If adhesive or
sealing compound gets on skin or clothing, wash immediately with soap and water.
9.
Coat threads of air temperature sensor (11) with pipe sealing compound and install in air intake manifold (4).
10.
Apply lubricating oil to new seal ring (13) and install in intake manifold (4)
11.
Install turbo boost sensor (10) on intake manifold (4) and secure in place with two retaining bolts (12). Tighten bolts to
21-26 lb-in (2.4-2.9 Nm).
12.
Connect engine wiring harness (9) to turbo boost sensor (10) and air temperature sensor (11).
15
14
14
15
2
3
4
1
5
7
6
