8.3
WEATHER PACK AND METRI-PACK 280 CONNECTORS
5. Grasp the cable and push it forward through the connector cavity into the tool while
holding the tool securely in place. See Figure 8-11.
Figure 8-11
Removal Tool Procedure
6. The tool will press the locking tangs of the terminal. Pull the cable rearward (back through
the connector). Remove the tool from the connector cavity.
7. Cut the wire immediately behind the cable seat and slip the new cable seal onto the wire.
All information subject to change without notice.
8-16
6SE497 9709 Copyright © 1997 DETROIT DIESEL CORPORATION
