TM 9-2320-302-20
0210 00-2
WINDSHIELD WIPER MOTOR AND LINKAGE REPLACEMENT - CONTINUED
0210 00
REMOVAL - CONTINUED
8.
Disconnect short link bar (12) from wiper motor crank (13).
9.
Remove three screws (14) and wiper motor (5) from bracket (8).
10.
Remove two nuts (15), screws (16), and pivot assembly (17) from firewall.
11.
Pry connecting link (2) from pivot assembly (17).
12.
Remove rubber seal (18) from ball joint of pivot assembly (17). Discard rubber seal.
INSTALLATION
1.
Install new rubber seal (18) to ball joint of pivot assembly (17).
2.
Install connecting link (2) to pivot assembly (17).
3.
Install pivot assembly (17) to firewall with two screws (16) and nuts (15).
4.
Install wiper motor (5) to bracket (8) with three screws (14). Tighten screws to 55 lb-in (621 Ncm).
5.
Connect short link bar (12) to wiper motor crank (13).
6.
Position bracket (8) and wiper motor (5) to firewall.
7.
Install two spacers (11), washers (10), and screws (9). Tighten screws to 60-84 lb-in (678-949 Ncm).
2
4
8
7
6
11
5
10
9
3
8
13
12
14
1
18
17
15
16