DDEC TROUBLESHOOTING
10. Pull the cable back through the connector until a click is heard.See Figure 8-5. Position
the seal into the connector.
Figure 8-5
Pulling the Terminal to Seat
NOTE:
For ECM 30-pin connectors, put locking tang opposite lettered side.
8.2.2
Removal and Repair
A tang on the terminal locks into a tab molded into the plastic connector to retain the cable
assembly. Remove Metri-Pack 150 terminals using the following instructions.
All information subject to change without notice.
6SE497 9709 Copyright © 1997 DETROIT DIESEL CORPORATION
8-9
