8.2 METRI-PACK 150 CONNECTORS 8.2 METRI-PACK 150 CONNECTORS Metri-Pack 150 series connectors are "pull-to-seat" connectors.  Each wire must be pushed through the connector prior to crimping the terminal. Cable seals are inserted into the shell of the connector and hold many wires.  Metri-Pack 150 connectors are listed in Table 8-2. ECM Engine Harness ECM Vehicle Interface Harness Connector P/N: 12034400 Connector P/N: 12034398 Terminal P/N: 12103881 Terminal P/N: 12103881 Seal In Connector Seal In Connector Plug P/N: 12034413 Plug P/N: 12034413 ECM Communication Harness Connector Temperature Sensor Harness Connector P/N: 12066317 Connector P/N: 12162193 Terminal P/N: 12103881 Terminal P/N: 12103881 Seal In Connector Seal In Connector Plug P/N: 12034413 Plug P/N: Not Applicable Pressure Sensor  Harness Fire Truck Pressure Sensor (PGS) Connector P/N: 12047909 Connector P/N: 12065287 Terminal P/N: 12103881 Terminal P/N: 12103881 Seal In Connector Seal In Connector Plug P/N: Not Applicable Plug P/N: Not Applicable SRS  Harness TRS  Harness Connector P/N: 12162193 Connector P/N: 12162197 Terminal P/N: 12103881 Terminal P/N: 12103881 Seal In Connector Seal In Connector Plug P/N: Not Applicable Plug P/N: Not Applicable Injector  (Gray) Injector  (Black) Connector P/N: 12162830 Connector P/N: 12040947 Terminal P/N: 12103881 Terminal P/N: 12103881 Seal P/N: Not Applicable Seal P/N: Not Applicable Plug P/N: 12034413 Plug P/N: 12034413 Table 8-2 Metri-Pack 150 Connector Part Numbers 8.2.1 Installation Metri-Pack 150 connectors are of the "pull-to-seat" design.  The cable is pushed through the seal and correct cavity of the connector before crimping the terminal to the cable.  It should be stripped of insulation after it is placed through the seal and connector body.  Use the following instructions for terminal installation: All information subject to change without notice. 8-4 6SE497  9709   Copyright © 1997 DETROIT DIESEL CORPORATION