TM 9-2320-302-20
0159 00-2
TRAILER HAND BRAKE REPLACEMENT - CONTINUED
0159 00
REMOVAL - CONTINUED
NOTE
Tag tubes and connectors to aid in installation.
2.
Remove three tubes (4) and connectors (5) from trailer hand brake (6).
3.
Remove clamp (7), trailer hand brake (6), and turn signal switch assembly (8). Set turn signal switch assembly aside.
4.
Remove screw (9), handle (10), three screws (11), and bracket (12) from trailer hand brake (6).
5.
Back off jamnut (13) and remove handle base (14), jamnut, and knob (15) from handle (10).
INSTALLATION
1.
Install knob (15), jamnut (13), and handle base (14) on handle (10). Tighten jamnut.
2.
Install bracket (12), three screws (11), handle (10), and screw (9) on trailer hand brake (6).
3.
Install trailer hand brake (6) and turn signal switch assembly (8). Tighten clamp (7).
WARNING
•
Adhesives and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin
and clothing. To avoid injury or death, keep away from open fire and use in a well-ventilated area. If
adhesives or sealing compound contacts skin or clothing, wash immediately with soap and water.
•
Ensure all air lines and fittings are clear of debris and excess pipe sealing compound does not enter air
lines or fittings. Failure to follow this warning could result in injury to personnel or damage to equip-
ment.
4
5
14
13
10
15
8
7
6
6
15
10
11
9
12
