TM 9-2320-302-20
0110 00-1
COLLISION WARNING SYSTEM (CWS) ANTENNA ALIGNMENT
0110 00
THIS WORK PACKAGE COVERS
Vertical Alignment, Horizontal Alignment
INITIAL SETUP
Test Equipment
Cartridge, CWS (Item 7, WP 0236 00)
Pro-link MPSI Reader (Item 33, WP 0236 00)
Tools and Special Tools
Tool kit, general mechanic’s (Item 36, WP 0236 00)
Level, digital (Item 23, WP 0236 00)
Personnel Required
Three
Equipment Condition
Vehicle parked on level ground (TM 9-2320-302-10)
NOTE
•
To ensure accurate alignment of CWS antenna, vertical and horizontal ground surface angles must be
known in relation to level and compensated for during antenna alignment.
•
Always perform vertical alignment first.
VERTICAL ALIGNMENT
1.
Place digital level (3) vertically on CWS antenna (1). Take reading to determine which direction antenna must be
adjusted.
2.
Loosen four screws (2) on side of CWS antenna (1) enough to allow repositioning of antenna without free travel.
3.
Holding digital level (3) vertically on CWS antenna (1), pivot top or bottom of antenna until reading on level is 1 degree
below vertical (89 degrees if ground surface is level).
4.
Tighten four screws (2).
2
1
3
