TM 9-2320-302-20
0097 00-2
OIL PRESSURE SENDING UNIT REPLACEMENT - CONTINUED
0097 00
REMOVAL - CONTINUED
4.
Depress collar (6) and remove air line (7) from fitting (8).
5.
Remove fitting (8) from cab air junction block (9).
6.
Disconnect electrical connector (10) from oil pressure sending unit (11).
7.
Remove oil pressure sending unit (11) from cab air junction block (9).
INSTALLATION
WARNING
Adhesives and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin
and clothing. To avoid injury or death, keep away from open fire and use in a well-ventilated area. If
adhesives or sealing compound contacts skin or clothing, wash immediately with soap and water.
Ensure that all air lines and fittings are clear of debris and excess pipe sealing compound does not enter
air lines or fittings. Failure follow this warning could result in injury to personnel or damage to equip-
ment.
1.
Lightly coat threads of oil pressure sending unit (11) with pipe sealing compound. Install sending unit on cab air junc-
tion block (9).
2.
Connect electrical connector (10) to oil pressure sending unit (11).
3.
Lightly coat threads of fitting (8) with sealing compound. Install fitting on cab air junction block (9).
4.
Install air line (7) on fitting (8), completely in collar (6).
8
9
11
10
7
6
