TM 9-2320-302-10
0005 00-4
OPERATION UNDER USUAL CONDITIONS - CONTINUED
0005 00
START ENGINE - CONTINUED
6.
When engine starts, release engine start button. If engine fails to start, prime fuel system
by pumping fuel filter/water separator valve (1) for two minutes. Press engine start but-
ton. If engine still fails to start, pump valve for 30 seconds. Press engine start button. If
engine still fails to start, notify Unit Maintenance.
CAUTION
DO NOT run engine above idle speed until oil pressure gage indicates at least
15 psi (100 kPa) at idle speed.
7.
DO NOT run engine above 600 rpm until normal oil pressure, 15 psi (100 kPa), is indi-
cated on engine oil pressure gage.
8.
Monitor gages and indicators. If after ten seconds there is no indication of oil pressure,
shut down engine and perform troubleshooting.
OPERATE TRANSMISSION
1.
Transmission Ranges.
a.
R (Reverse) is used to back up the vehicle. Vehicle must be brought to a complete
stop before shifting from a forward range to R or vice versa. Light on panel will
illuminate and the digital display will display R when reverse is attained.
CAUTION
DO NOT allow truck to coast in N (Neutral). This can result in severe trans-
mission damage. When in N, engine braking is not available.
1
