TM 9-2320-283-20-3
WHEELS.
3-207. REAR HUB, BEARINGS, AND SEALS REPLACEMENT (Continued).
LOCATION/ITEM
ACTION
REMARKS
A. REMOVAL (Continued).
8. Cup (4) and cup
Remove.
(8).
Use suitable puller or
long brass drift and tap
alternately on outer
edge until removed. Dis-
card items (4) and (8).
9. Eight studs (7).
Remove.
10. Ten bolts (5).
May be removed if damaged.
Press out.
B. CLEANING.
WARNING
Do not use compressed air to dry
bearings.
A spinning bearing can fly
apart.
Failure to heed warning can
result in serious personal injury.
11. All parts.
a. Clean all parts in dry-
cleaning solvent and
Refer to paragraph 3-4.
allow parts to air dry.
b. If bearings are to be
reused:
1. Remove surface oil and
gum deposits.
2. Clean with drycleaning
solvent.
3. Wipe dry. Do not use
Refer to TM 9-214 for
compressed air.
information on mainten-
ance.
4. Coat with light film
of oil.
Wrap bearings
in paper until you are
ready to install them.
3-1230
