TM 9-2320-283-20-3
Section XII. WHEELS
3-201. GENERAL.
This section provides procedures authorized at the organizational maintenance
level to replace wheel components.
To find a specific procedure contained in
this section, see the task summary below.
Adapter
(80201) 446.
Plug
(80201) 715.
Wrench, hexagon locknut, 4-1/8 inch
(45225) 1915.
3-202. TASK SUMMARY.
INITIAL SETUP
EQUIPMENT CONDITION
APPLICABLE CONFIGURATIONS
PARAGRAPH
CONDITION DESCRIPTION
All.
(Refer to specific paragraph for this
information).
TEST EQUIPMENT
None.
SPECIAL TOOLS
Handle
(80201) 450237.
Adapter
(80201) 427.
Plug, bearing
(80201) 706.
Wrench, hexagon locknut,
2-1/4 inch
(45225) 1920.
MATERIALS/PARTS (P/N)
Solvent, drycleaning, SD-2
Item 29, Appendix C.
Rag, wiping
Item 22, Appendix C.
Solution, soap
Item 28, Appendix C.
Antiseize compound
Item 5, Appendix C.
Sealant, flange
Item 23, Appendix C.
Pin, cotter
(52304) H1005727.
Seal assembly, front axle bearing
(80201) 35066.
Gasket, hubcap
(26151) 330-3009.
Oil, lubricating: Gear GO
Refer to LO 9-2320-283-12.
Seal, rear axle bearing
(80201) 47697.
PERSONNEL REQUIRED
Two (MOS-63S).
SPECIAL ENVIRONMENTAL CONDITIONS
Vehicle on level ground with front
wheels straight.
3-1203
