TM 9-2320-283-10
Table 3-1. Troubleshooting - Continued
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Step 2.
Check for proper operation of power steering.
With truck standing still, turn wheels from stop to stop
and hold against each stop for 5 seconds. Repeat this sev-
eral times. If steering problem continues, notify Organi-
zational Maintenance.
22.
FOAMY FLUID ON TRANSMISSION DIPSTICK.
Check level on dipstick with engine at idle and truck on level ground.
If transmission temperature is 100-250°F and fluid level is
about the HOT RUN band or if temperature is below 100°F and
fluid level is above COLD RUN band, notify Organizational
Maintenance.
23.
SLOW OR ERRATIC TRANSMISSION ENGAGEMENT.
Check dipstick to make sure fluid is at proper level (refer to LO 9-2320-283-
12).
If fluid is sufficient, notify Organizational Maintenance.
24.
TRANSMISSION FLUID TEMPERATURE GAGE INDICATES FLUID IS OVER-
HEATING DURING NORMAL OPERATION. NORMAL OPERATING TEMPER-
ATURE RANGE IS 100°F TO 250°F.
Step 1.
Check transmission fluid level on dipstick.
Notify Organizational Maintenance if additional fluid is re-
quired.
Step 2.
Check dipstick for evidence of foamy fluid.
Refer to Malfunction 22.
Step 3.
Check dipstick for evidence of discoloration that could indicate
water/antifreeze in fluid.
If there is discoloration of fluid, notify Organizational
Maintenance.
3-12
