TM 9-2320-273-20
TRANSMISSION.
6-14. TRANSMISSION CONTROL HEATER MAINTENANCE (Continued).
LOCATION/lTEM
ACTION
REMARKS
B. INSTALLATION (Continued).
39. Elbow (43).
a. Coat threads with liquid
tefIon.
b. Screw into engine block.
Near power steering pump.
40. Sending unit (42).
Screw onto elbow (43).
41. Harness (17).
a. Install two wires to send-
Install as tagged at disassembl y.
ing unit (42) with two
screws (41).
b. Install one wire to alter-
nator positive post with
washer (47) and nut (46).
NOTE
Follow-on maintenance action required:
a. Install fuel tank; refer to para 4-23B and C.
b. Install supply air reservoir (M916 thru M920
only); refer to para 9-166 and C.
c. Connect batteries; refer to para 5-37B.
d. Install floor access plate; refer to para 6-11C.
e. Install ether cylinder; refer to para 4-30B
and C.
C. OPERATIONAL CHECK.
42. Engine.
Start up (see TM 9-2320-
273-10).
43. Lamp (20).
Should light and remain on
See decal (22) for further
until control temperature is
instructions.
in excess of 0°F (-17.8°C).
44. Engine.
Shut down (see TM 9-2320-
273-10).
6-52
