TM 9-2320-273-20
TRANSMISSION
6-14. TRANSMISSION CONTROL HEATER MAINTENANCE (Continued).
LOCATION/lTEM
ACTION
REMARKS
B. INSTALLATION.
22. Two nuts (11).
Screw one nut (11) onto
Nut must be exactly 1 7/8
each of two rods (14).
inches from end of rod for
proper installation clearance
(see exploded view).
23. Two washers (10) and
Slide onto two rods (14).
At same end of rods you
one heater (7).
installed nuts (11) on in
step (22).
24. Two nuts (5) and washers
Install on two rods (14)
Check for 1 7/8 inch measure-
(6).
and adjust down to con-
ment again from nuts (11) to
tact heater (7).
end of rods (14). Adjust if
necessary.
25. Assembled heater (7),
Position on top edge of
two nuts (11), nuts (5),
transmission.
washers (6), washers (10),
and rods (14).
Do not over tighten nuts (5) or (11).
Adjust to retain heaters (7) snugly
against transmission control. Over
tightening will cause heaters to distort
and pull away from control block on
transmission.
26. Second-heater (7), two
a, Install at bottom of two
nuts (11), washers (10),
rods (14).
washers (6), and nuts (5).
b. Tighten two bottom nuts
If heater(s) start to bow, loosen
(11) and two bottom nuts
nuts (11) until heater(s) are
(5) to snug two heaters
straight, then lock in place with
to transmission.
nuts(11).
6-44
