TM 9-2320-273-20
TRANSMISSION.
6-11. PNEUMATIC CONTROL LINE MAINTENANCE (Continued).
LOCATION/lTEM
ACTION
REMARKS
A. REMOVAL.
1. Two screws (5) and washers (6). Loosen and remove.
2. Retainer (7).
Remove.
3. Ten screws (13).
Loosen and remove.
4. Access plate (12).
Remove.
5. Grommet (9).
Remove,
6. Three bolts (11).
Loosen and remove.
7. Three bolts (1) and
Loosen and remove.
washers (2).
8. Control line (8) and
Remove
Discard two gaskets (3).
two gaskets (3).
B. INSPECTION.
9. Control line (8).
a. Inspect for:
1. Cracks.
2. Leaks.
3. Kinks.
b. Blow air through to see
that line is not clogged.
C. INSTALLATION.
10. Control line (8) and
a. Attach to ratio selector
two new gaskets (3).
(4) using three bolts (1)
and washers (2).
b. Attach to transmission (10)
using three bolts (11).
11. Six bolts (1) and (11).
Tighten to 18 Ib-ft (24 N•m)
using torque wrench.
12. Grommet (9).
Install.
13. Access plate (12).
Install.
14. Ten screws (13).
Install and tighten.
15. Retainer (7).
Install.
16. Two screws (5) and
Install and tighten.
washers (6).
Replace if necessary.
6-22
