TM 9-2320-273-20
BATTERIES AND ALTERNATOR.
5-39. BATTERY CABLES MAINTENANCE (Continued).
LOCATION/lTEM
ACTION
REMARKS
A. REMOVAL (Continued).
5. Cable (4).
Remove from terminal (21).
6. Nut (7) and washer (6).
Remove from terminal (5).
7. Cable (4).
Lift from terminal (5) and remove.
8. Nut (10) and washer (9).
Remove from terminal (8).
9. Cable (11).
10. Nut (27).
11. Cable(11).
12. Cables (24) and (26).
13. Slave receptacle (18).
B. INSTALLATION.
14. Slave receptacle (18),
and gasket (15).
15. Cables (24) and (26).
16. Cable (11).
17. Nut (27).
Remove from terminal (8).
Remove from terminal (25).
Lift from terminal (25) and remove.
Remove two screws (16) and
washers (17); lift cables
from slave receptacle (18).
a. Remove four screws (20),
eight washers (19) and four
nuts (14).
b. Remove slave receptacle (18)
with rubber gasket (15).
Install to battery box with four
screws (20), eight washers
(19) and four nuts (14).
Install to slave receptacle (18)
with two screws (16) and
washers (17).
NOTE
After installation of cables, cover terminals
and nuts with light coat of lubrication.
Connect to terminal (25).
Install on terminal (25) and tighten.
Remove from battery
terminals as shown,
if required.
Replace if damaged.
Reconnect to battery
terminals as shown.
5-126
