TM 9-2320-273-20
STARTING AND STARTING CONTROL.
5-34. ENGINE START BUTTON MAINTENANCE (Continued).
LOCATION/lTEM
ACTION
REMARKS
A.
REMOVAL (Continued).
3. Two screws (3) and
Remove.
washers (4).
4. Four wires (5).
Remove.
5. Knurled nut (8).
Remove,
6. Starter button (6).
Remove.
7. Adjusting hex nut (7).
Remove.
B.
INSTALLATION.
8. Adjusting hex nut (7).
Adjust to proper depth on
starter switch to allow
installation of knurled nut (8).
9. Starter button (6).
Replace in panel.
10. Knurled nut (8).
Install and tighten.
11. Four wires (5), two
InstalI according to figure and
washers (4) and screws (3).
tighten.
12. Hinged instrument
Raise into place.
panel (2).
13. Four quarter-turn
Tighten.
screws (1).
5-102
