TM 9-2320-273-20
BODY AND CAB.
11-33. TAIL ROLLER MAINTENANCE (Continued).
LOCATION/lTEM
ACTION
REMARKS
A. REMOVAL (Continued).
5. One bolt (3), one nut (6),
Remove.
and the roller mounting
bracket (5).
6. Roller mounting bracket
Pull tail roller’s axle shaft out of
(5) and tail roller (2).
roller mounting bracket.
7. Four washer base nuts (1)
Unscrew and remove second
Removal is necessary only
and washer base bolts (7).
roller mounting bracket (4).
if replacement is needed
due to wear or damage.
NOTE
If bearings inside tail roller or axle
shaft are to be serviced, refer to
Direct Support Maintenance.
B. INSTALLATION.
8. One roller mounting bracket
Aline with holes in frame rail (8)
Make sure you use correct
(5).
and install with four washer base
holes in roller mounting
bolts (7) and washer base nuts
bracket. M916 uses two
(1).
top rows; M920 uses
bottom two rows.
9. Second roller mounting
Slide over axle shaft of tail roller
bracket (5).
(2) and secure with bolt (3) and
nut (6).
10. Tail roller (2) with assembled
a. Lift into position with hoist and
First mechanic operates
roller mounting bracket (5).
aline mounting holes with those
hoist while second guides
in frame rails (8) and tail roller
assembly.
axle into first roller mounting
bracket already installed.
b. Block in position with axle
stands.
11. Four washer base bolts (7)
Install thru second roller mounting Make sure you use correct
and washer base nuts (1).
bracket (5) and frame rail (8).
bolt holes in roller mount-
ing bracket. M916 uses
two top rows; M920 uses
bottom two rows.
11-110
