TM 9-2320-273-20
BODY AND CAB.
11-28. HEATER CONTROL PANEL MAINTENANCE (Continued).
LOCATION/lTEM
ACTION
REMARKS
A. REMOVAL OF KNOB AND CABLE.
1. Clip (6).
Loosen. Remove cable (1) from
clip.
2. Cable end (8).
Slide off of pin (7).
3. Setscrew (9).
Loosen. Remove knob (5).
4. Two screws (3).
Remove rear cover (2) from front
cover (4).
5. Nut (11).
Unscrew from collar (10).
6. Cable tie (12)
Cut and remove from cable
(1) and four other cables.
7. Cable (1).
Remove through rear cover (2),
nut (11), and front cover (4).
B.
INSTALLATION OF KNOB AND CABLE.
8. Cable (1).
Thread cable end (8) through front
cover (4), nut (11), and rear cover
(2).
9. Cable tie (12)
Install around cable (1) and
four other cables.
10. Nut(n).
Screw onto collar (10) and tighten.
11. Rear cover (2).
SIide onto front cover (4) and
secure with two screws (3).
12. Knob (5).
a. Place onto cable (1).
b. Tighten setscrew (9).
13, Cable end (8).
Slide onto pin (7).
14. Cable (1).
Fasten with clip (6).
C .
OPERATIONAL CHECK.
15. Knob (5).
Pull out and push in. Check that
Check for binding in
pin (7) swings as you move the
cable (1), if pin (7) fails to
knob.
swing.
11-92 Change 1
