TM 9-2320-273-20
STEERING MECHANISM.
10-21.2. STEERING STOP INSPECTION AND ADJUSTMENT PROCEDURES.
THlS TASK COVERS: (APPROXIMATE TIME REQUIRED FOLLOWS TASK DESCRIPTION.)
a. Inspection
b. Adjustment
1/2 Hour Total.
EQUIPMENT CONDITION
APPLICABLE CONFIGURATIONS
PARAGRAPH
M915
None
None
Analyzer, Power Steering, NSN 4910-01-160-3618
P/N J26487 (33287)
SPECIAL TOOLS
Pushrod Driver (fabricate IAW Section 10-21.1 G, page 10-85)
P/N DTA177323 (19207)
Puller, NSN 5120-00-595-9305
P/N GGG-P-781 (81348)
Torque Wrench, NSN 5120-00-221-7983
P/N SW130-301 (10001)
Multiplier, Torque Wrench NSN 5120-01-142-6941
P/N 392 (87641)
Steering Stop Template (fabricate lAW Section 10-21.1 G, page 10-85)
MATERIALS/PARTS(P/N)
Steering Arm Kit, 2MPS-3993 (78500)
Includes:
Cotter Pin, (MS24656-498 (96906)
Key, 16X202 (78500)
Nut, Drag Link/Steering Arm, MS35692-69 (96906)
Nut, Knuckle/Steering Arm, MS35692-1824 (96906)
Boot, Grease, 415172C1 (89346)
Steering Arm, 3133-G-6663 (78500)
One (MOS-63S)
TM 9-2320-273-10
TM 9-2320-273-24&P
TM 9-2320-273-34
Table 10-2.
SPECIAL EVIRONMENTAL CONDITIONS
Vehicle Parked on Level Ground.
GENERAL SAFETY INSTRUCTIONS
Engine OFF.
Transmission in Neutral.
Parking Brake Set.
Rear Wheels Chocked.
10-84.8 Change 3
INITIAL SETUP
TEST EQUIPMENT
CONDITION DESCRIPTION
PERSONNEL REQUIRED
REFERENCES (TM)
TROUBLESHOOTING REFERENCES
