TM 9-2320-273-20
WHEELS AND TIRES.
10-15. REAR WHEEL BEARINGS, SHAFTS, AND SEALS MAINTENANCE (Continued).
LOCATION/lTEM
ACTION
REMARKS
10. Outer wheel bearing (12)
b. If bearings are to be reused:
and inner wheel bearing
1. Remove surface oil and
(17) (continued).
gum deposits.
2. Clean with solvent.
3. Wipe dry, Do not use
See TM 9-214 for information
compressed air.
on maintenance.
4. Coat with a light film of
oil. Wrap bearings in paper
until you are ready to
install them.
11. (M915 only) Oil slinger
Install.
(14), five washers (15)
and capscrews (16).
12. Inner wheel bearing (17).
a. Use bearing packing tool
to pack with grease.
b. Place in wheel/hub/drum
assembly (7) so that smaller
end will point away from
truck.
13. New inner bearing seal (18)
Place over inner wheel bearing
and inner oil seal wiper (19).
(17) in wheel/hub/drum assem-
bly (7). Lettering should face
truck when wheel is mounted.
14. Wheel/hub/drum assembly
Place in position over brake
(7).
(20), using wheel dolly.
15. Outer wheel bearing (12).
a. Use bearing packing tool
to pack with grease.
b. Place on hub with small
end towards truck.
10-58 Change 2
