TM 9-2320-273-20
Table 10-2. Steering Troubleshooting Procedures (Continued).
MALFUNCTION.
TEST OR INSPECTION.
CORRECTIVE ACTION.
2.
HARD STEERING (Continued):
Step 6.
Inspect drag link for damage.
Replace drag link (para 10-19).
Step 7.
Check steering gear for proper adjustment.
Refer to Direct Support Maintenance.
Step 8.
Inspect axle shaft for damage (M916 thru M920).
Refer problem to Direct Support Maintenance.
3.
VEHICLE WANDERS OR PULLS TO ONE SIDE:
Step 1.
Check U-bolts for tightness.
Tighten U-bolts (125-165 Ib-ft (170-224 N.m) for M915,
200-270 Ib-ft (271-336 N-m) for M916 thru M920).
Step 2.
Check front spring pin for damage by using a pry bar. No noticeable play is
allowed.
Refer to Direct Support Maintenance.
Step 3.
Check auxiliary cylinder for damage (M916 thru M920).
Replace cylinder (para 10-23).
Step 4.
Check drag link for damage.
Replace drag link (para 10-19).
Step 5.
Check tie rod for looseness or damage.
Adjust or replace tie rod assembly (para 10-20).
Step 6.
Check for dragging brake by jacking vehicle and spinning wheel by hand.
Adjust brake (para 9-31 and 9-32).
Step 7.
Check hub and drum for damage.
Replace (para 10-13 or 10-14, as applicable).
10-6
