TM 9-2320-273-20
BRAKE SYSTEM.
9-32. FRONT BRAKE SHOES MAINTENANCE (M916 THRU M920) (Continued).
LOCATION/lTEM
ACTION
REMARKS
C. INSTALLATION.
If you replace any brake shoe, replace all the
shoes on that axle. A combination of new
and old shoes on the same axle will cause
uneven braking. Make sure that the brake shoes
are clean before you install them. Be careful
not to get grease or oil on the linings as you
assemble them.
12. Wedge (19) and snap
Install into spider (20).
ring (18).
13. Two plungers (17), two
Install as shown.
new seals (16), two retainers
(15), two plungers (14),
two anchors (13), two
adjusting bolts (12), two
springs (10) and (11) and
two retainers (9).
14. Guides (24) and (22), cap
Install pawl (21) with
(23), pawl (21), two guides
(25), and two Iockplates
guides (24) and (22),
and cap (23).
(26).
15. Two brake shoes (8).
Install.
16. Two pins (1), two plates
Install pins (1) and plates
(6), two springs (5), two
(6) with springs (5),
washers (3), two nuts (2),
washers (3), nuts (2),
and two new cotter pins
and new cotter pins (4).
(4).
17. Two springs (7).
Install with brake spring
pliers.
NOTE
Follow-on maintenance action required
before adjustment:
Install hub and drum; refer to para
10-14B and C.
9-130
