TM 5-2330-361-14&P
axle while the slack adjuster, push rod, and power
chamber mounting face are in the same position as
on the existing axle (see figure 10-17).
n. Tack weld the power chamber in place.
o . Check all clearances and weld the cast re-
tainer on the axle using 5/32 (3.97 mm) E7018 elec-
t r o d e (see figure 10-18). Peen immediately after
welding.
Assemble the hub and drum assem-
P.
blies to the axle and adjust the brakes.
q. Again compare the slack adjuster angle, push
rod angle, and push rod to mounting face angle with
that of the original axle. Also, check for bind be-
tween the push rod and push rod hole. If this checks
out, weld the power chamber bracket on.
FIGURE 10-14. WEDGING BETWEEN CAST
RETAINER AND AXLE TO OBTAIN FINE
ADJUSTMENT OF AXLE CENTERS.
FIGURE 10-15 MARKING CHECK POINTS FOR DIAGONAL MEASUREMENT
FIGURE 10-16. EQUALIZING AXLES THROUCH DIAGONAL MEASUREMENT.
10-7 Change 3