TM 5-2330-325-14&P
Table 4-3. Unit Troubleshooting (Continued)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
WHEEL ASSEMBLY
1.
HUB GENERATES EXCESSIVE HEAT.
Step 1.
Inspect hub for damage.
Replace damaged hub in accordance with paragraph 4-61.
Step 2.
Inspect hub for improper binding or excessive end play.
Adjust hub and bearings in accordance with paragraph 4-61.
WARNING
Before putting hand to hub, hold hand close to hub to check for excessive
heat radiation. Hub may be hot. This will prevent skin burns caused by hot
metal.
Step 3.
Inspect bearings for wear or damage.
Replace damaged or worn components in accordance with paragraph 4-61.
