TB 9-2320-360-13&P-1
WARN I N G
Jewelry can catch on equipment and cause injury or short across electrical circuit and cause severe
burns or electrical shock. Remove rings, bracelets, watches, necklaces, and any other jewelry
before working around HET Tractor.
CONTINUITY TEST
(1) Disconnect A/C compressor receiver/
dryer harness black wire from A/C
compressor clutch harness.
(2) Set multimeter switch to ohms.
(3) Is there continuity measured on black
wire from A/C compressor clutch
connector to ground?
(a) If there is no continuity, repair
black wire from A/C compressor
clutch connector to A/C evaporator
harness switch harness connector,
(See WP 0057 00, Fig j) or notify
DS Maintenance. Verify repair, go
to Step 13 of this fault.
(b) If there is continuity, connect black
wire to A/C compressor clutch
harness and go to Step 5 of this
fault.
VISUAL INSPECTION
(1) Inspect A/C condenser for blockage,
debris, or damage.
(a) If A/C condenser is blocked,
remove blockage and debris.
Verify repair, go to Step 13 of this
fault.
(b) If A/C condenser is damaged,
notify DS Maintenance.
(c) If A/C condenser is free from
blockage, debris, and damage, go
to Step 6 of this fault.
HETF00446
0017 00-7