TB 9-2320-335-13&P
15-3. ENGINE MOUNT AND INSULATOR MAINTENANCE (Cont'd)
NOTE
Install sling bracket on rear of engine first.
Use four 15x25-mm capscrews to install lifting sling on engine.
5.
Install engine lifting sling on engine (2) and right cylinder head (7) with two capscrews (6).
6.
Install sling bracket (4) on left cylinder head (5) with two capscrews (3). Tighten capscrews (6) and
(3) and install bracket (4) on engine lifting sling with pin (1).
WARNING
Direct all personnel to stand clear during hoisting operation.
Failure to do this may cause injury to personnel.
7.
Attach hoist to engine lifting sling. Slowly raise engine (2) enough to remove engine mount (8) and
insulator (10) from engine mount bracket (9).
8.
Remove engine mount (8) and insulator (10) from engine mount bracket (9).
b. Disassembly
Remove four locknuts (13), washers (12), capscrews (11), washers (12), starter bracket (14) (for right
mount), and insulator (10) from engine mount (8). Discard locknuts (13).
c. Assembly
Install insulator (10) and starter bracket (14) (for right mount) on engine mount (8) with four
washers (12), capscrews (11), washers (12), and locknuts (13). Tighten locknuts (13) to 37 lb-ft (50 Nm).
15-4