TB 9-2320-335-13&P
7-23. PARKING BRAKE CABLE REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
Equipment Condition
General mechanic's tool kit:
Wheels chocked and parking brake released
automotive (Appendix B, Item 1)
(TM 9-2320-387-10).
Access cover removed (para. 10-58.4).
Manual References
Muffler and catalytic converter removed
TM 9-2320-387-10
(TM 9-2320-387-24-1).
TM 9-2320-387-24-1
Rear propeller shaft removed
TB 9-2320-335-13&P, Appendix E
(TM 9-2320-387-24-1).
Maintenance Level
Unit
NOTE
Replacement procedures for left and right side parking brake
cables are basically the same. This procedure covers the left side.
a. Removal
1.
Remove clevis pin (6), clevis bolt (2), washers (3) and (7), and clevis (1) from caliper lever (8).
2.
Remove parking brake cable (4) from cable bracket (5).
NOTE
Use 1/2 in. line wrench for removing parking brake cable from
caliper bracket.
3.
Remove retaining ring (11) from parking brake cable (4).
4.
Remove parking brake cable (4) from equalizer cable bar (9) and C-beam (10).
5.
Pull parking brake cable (4) forward and remove from vehicle.
b. Installation
1.
Install parking brake cable (4) over rear front crossmember (13) and muffler bracket (12).
2.
Slide parking brake cable (4) through C-beam (10) and install on equalizer cable bar (9).
3.
Secure parking brake cable (4) to C-beam (10) with retaining ring (11).
4.
Install parking brake cable (4) on cable bracket (5).
5.
Install clevis (1) on caliper lever (8) with washer (3), clevis bolt (2), washer (7), and clevis pin (6).
7-34
