TB 9-2320-302-13&P-2
WORK LIGHT CONNECTOR
Remove the work light connector from
the b-pillar on both sides of the cab.
REQUIRED TOOLS:
5/32" Drill Bit and Drill
Small Slotted (Flat-Tip) Screwdriver
1.) Drill out the two rivets securing
each connector.
3.) Leave the wires hanging approximately
2.) Pull the connectors out from the
6" out of the b-pillars as they will be
b-pillars and disconnect the wires
reconnected later.
using the small screwdriver.
NOTE: Re-install the screws on the connectors and save the connectors for later re-installation.
ArmorWorks
0038 00-21