TB 9-2320-279-13&P-3
0028
INSTALLATION
WARNING
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. To avoid injury or death, keep away from open fire and
use in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or
clothing, wash immediately with soap and water.
NOTE
There are five marker lights on the rear lightbar panel and two marker lights on the lower side
panels. All seven lamp assemblies are installed the same way. Right lower side panel lamp
assembly shown.
1. Apply electrical sealant to lamp assembly (3).
2. Connect light connector (6) to lamp assembly (3).
3. Install lamp assembly (3) to module (7) with four lockwashers (5) and screws (4).
4. Install lamp cover (2) on lamp assembly (3) with two screws (1).
END OF TASK
0028-3