II106700-5
Rev. B
Page 59
Figure 35a. The Rear Side Cab Armor Panel installed.
2. Position the Cab Entry Hand Hold on top of the Rear Side Cab Armor Panels and
secure it (and the Panels) in place using two bolts (7/16 - 14 x 4.000 LG),
four flat washers (7/16 ID), and two locknuts (7/16 14). Do not tighten the bolts
and nuts at this time.
NOTE
The gap between the rear edge of the Armored Door and the front edge of the
Rear Side Cab Armor Panels should be 1/8 to 3/16 in. wide.
3. Verify that the gap between the rear edge of the Armored Door and the front edge
of the Rear Side Cab Armor Panels is 1/8 to 3/16 in. wide.