TB 9-2320-279-13&P-2
LOWER BRUSH GUARD REPLACEMENT - CONTINUED
0019 00
REMOVAL - CONTINUED
4.
With assistance, remove four bolts (10), washers (11), and left-side armor panel (12) from lower brush guard (13).
5.
With assistance, remove four bolts (15), washers (16), and right-side armor panel (14) from lower brush guard (13).
6.
Push two wiring harnesses (17) through holes in lower brush guard (13).
7.
Using lifting device, remove lower brush guard (13) from vehicle and place on flat surface.
8.
Remove lifting device, sling, and two lifting links from lower brush guard (13).
12
14
13
10,11
15,16
17
417-064
CLEANING AND INSPECTION
Clean and inspect all parts IAW General Maintenance Instructions (WP 0011 00).
INSTALLATION
WARN I N G
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-
sonnel.
N OT E
Lower brush guard weighs 219 lb (99 kg).
1.
Attach two lifting links, sling, and lifting device to top edge of lower brush guard (13). Position lower brush guard over
grille area at front of vehicle.
2.
Feed two wiring harnesses (17) through holes in lower brush guard (13).
3.
With assistance, position right-side armor panel (14) and install four washers (16) and bolts (15). Hand tighten bolts.
4.
With assistance, position left-side armor panel (12) and install four washers (11) and bolts (10). Hand tighten bolts.
5.
Install eight bolts (5), washers (6), washers (7), and new locknuts (8) to front edge of both side blast shields (9). Tighten
bolts to 35 lb-ft (47 Nm).
6.
Install six washers (2), bolts (1), washers (3), and new locknuts (4) to front edge of both side blast shields (9).
7.
Remove lifting device, sling, and two lifting links from lower brush guard (13).
0019 00-3