TB 2300-420-20-1
REPLACEMENT OF ONE PIECE CONTROL ASSEMBLY WITH TWO PIECE - Continued
6. Using rags and solvent, clean the general area of the shifting control bracket at top of transmission.
7. Using tape, measure rearward in vehicle from
point (A) 1 inch, and scribe a line.
8. Measure from point (B) to the right in vehicle
5/16 inch and scribe a line at intersection of point
(A) line.
9. Using hammer and punch, centerpunch point of
lines.
NOTE
Location tolerances is + 1/8 inch.
10. Once the pad and boss locations have been
determined, you must prepare the vehicle for
welding operations.
WARNING
WELDING IN THE VICINITY OF FUEL,
OIL AND HYDRAULIC FLUID IS
DANGEROUS. PLACE FLAMEPROOF
MATERIAL
BETWEEN
WELDING
AREA
AND
FUEL
TANKS.
SURROUND COMPONENTS WITH
WET RAGS OR CANVAS TO
PROTECT
AGAINST
WELD
SPLATTER. STATION A HELPER IN
THE IMMEDIATE AREA WITH AN
APPROVED FIRE EXTINGUISHER
BEFORE
BEGINNING
WELDING
OPERATIONS.
FAILURE
TO
ADEQUATELY PROTECT AGAINST
FIRE CAN CAUSE DEATH, INJURY,
AND DAMAGE TO EQUIPMENT
TA173294
56