TM 9-2320-363-10
3-11.
REAR WHEEL AND TIRE ASSEMBLY REPLACEMENT
(M917A1 AND M917A1 W/MCS) (Con’t).
stem (18).
position.
(2)
If replacing inner tire, connect hose (15) to inner wheel valve
(3)
Rotate wheel hub (20) until hub air port (5) is at 12 o’clock
Use caution when lifting or handling wheel and tire
assembly. It is heavy and could cause injury if improp-
erly lifted or if it falls on you.
NOTE
Wheel nuts on left side of vehicle are left hand threads
(turn right to loosen, turn left to tighten). Wheel nuts on
right side of vehicle are right hand threads (turn left to
loosen, turn right to tighten).
(4)
If replacing inner tire, position wheel and tire assembly on
wheel hub (20) with hand hold (7) (not containing valve stem) aligned with hub air
port (5). Install wheel nuts and handtighten.
(5)
Install spacer.
(6)
Position outer wheel and tire assembly on wheel hub (20)
with hand hold (7) (not containing valve stem) aligned with hub air port (5). Install
wheel nuts and handtighten.
(7)
Route inner wheel valve stem hose (15) through outer wheel
hand hold (17).
(8)
Lower and remove jack.
3-35
