REAR WHEEL AND TIRE ASSEMBLY REPLACEMENT
(M917A1 AND M917A1 W/MCS) (Con't).
Whenever inner and/or outer wheel lug nuts require
tightening or a wheel has been removed and replaced,
lug nuts must be torqued to the required torque. Failure
to follow this warning may result in serious injury to
personnel and damage to equipment.
Tightening pattern is identical for ail wheel assemblies.
Have Unit Main-
tenance apply proper torque to wheel
hub nuts (11) at 4 and 5 oclock position.
Position bracket (9) with wheel valve (10) and hoses attached
on wheel hub studs.
Install two hub nuts (11) and have Unit Maintenance apply
Connect inner wheel valve stem hose (15) to tee connector
Connect hose (19) to outer wheel valve stem (16).
Connect hub port connector (6) to hub air port (5).
Connect hose (8) to hub port connector (6).
Remove wheel blocks.
Inflate tires using CTIS (paragraph 2-17) or manual tire infla-
tion procedure (paragraph 3-8).