TM 9-2320-302-34
0029 00-10
OIL PUMP MAINTENANCE - CONTINUED
0029 00
ASSEMBLY - CONTINUED
NOTE
Diamond-shaped dowel must be oriented in relation to tubular-shaped dowel before installing in pump body
mounting surface.
13.
If removed, loosely place diamond-shaped dowel (26) in bore of pump body (20) mounting surface so that angular ori-
entation is perpendicular to center line through tubular-shaped dowel (27) within 5 degrees.
14.
Install diamond-shaped dowel (26) in bore of pump body (20) mounting surface. Top of diamond-shaped dowel should
be 0.307-0.323 in (7.8-8.2 mm) above surface when properly seated in bore.
15.
Place oil pump body (20), with cover side down, on press support. Lubricate two bushings (24) with clean engine lubri-
cating oil.
16.
Apply a thin film of lubriplate to bore of oil pump drive gear (23).
17.
Install longer end of internal oil pump drive gear and shaft assembly (22) in right side bushing as view from top rear.
26
20
27
+/- 5°
26
20
26