8.3
WEATHER PACK AND METRI-PACK 280 CONNECTORS
5. Push the crimped terminal into the connector until it clicks into place. Gently tug on the
cable to make sure it is secure. See Figure 8-9.
Figure 8-9
Inserting Terminal in Connector
8.3.2
Removal and Repair
Two locking tangs are used on the terminals to secure them to the connector body. Use the
following instructions for removing terminals from the connector body.
1. Disengage the locking tang, securing the connector bodies to each other. Grasp one half of
the connector in each hand and gently pull apart.
All information subject to change without notice.
8-14
6SE497 9709 Copyright © 1997 DETROIT DIESEL CORPORATION