TB 9-2320-279-13&P-4
0024
DECISION
No - Replace heavy-duty winch control valve harness. (WP 0049)Test 42 - Does high idle operate?
Yes - Repair wire 1854 (refer to TM 9-2320-315-14&P).Test 42 - Does high idle operate?
TEST 5 - Is continuity measured on remote control cable wires 1849 and 1854?
WARNING
Ensure electrical power is off prior to working on all electrical connections. Failure to comply
may result in injury or death to personnel.
Remove all jewelry such as rings, ID tags, bracelets, etc. prior to working on or around
vehicle. Jewelry and tools can catch on equipment, contact positive electrical circuits, and
cause a direct short, severe burns, or electrical shock. Failure to comply may result in injury
or death to personnel.
1. Set multimeter switch to ohms.
2. Connect positive (+) probe of multimeter to remote control cable, terminal D. Refer to schematics.
E
D
A
C
B
REMOTE CONTROL
CABLE
Figure 5.
3.
Connect negative (-) probe of multimeter to opposite remote control cable end, terminal D.
4.
Multimeter should display a reading less than 200 ohms. Note reading.
5.
Connect positive (+) probe of multimeter to remote control cable, terminal C.
6.
Connect negative (-) probe of multimeter to opposite remote control cable end, terminal C.
7.
Multimeter should display a reading less than 200 ohms. Note reading.
CONDITION/INDICATION
Is continuity measured on remote control cable wires 1849 and 1854?