1.
2.
3.
4.
5.
6.
7.
TM 9-2320-363-34-2
MAKE SURE LOCKS (1) ARE IN CLOSED POSITION.
REMOVE AND DISCARD NUT (2), WASHER (3), RUBBER WASHER (4), AND LOCK-ADJUST TAG
(5).
REMOVE AND DISCARD SCREW (6), WASHER (7), ROLLER (8), AND WASHER (9).
REMOVE AND DISCARD LOCK NUT (10), SCREW (11), WASHER (12), ROLLER (13), CAM PLATE
(14), AND WASHER (15).
REMOVE PRIMARY LOCK HANDLE (16) FROM TOP PLATE (17),
REMOVE AND DISCARD WASHER (18) FROM PRIMARY LOCK HANDLE (16).
REMOVE ROLL PIN (19), SPRING (20), LOCK BAR (21), AND HANDLE (22). DISCARD ROLL PIN,
SPRING, AND LOCK BAR.
W A R N I N G
When removing spring, compress spring slightly and relieve tension slowly.
Failure to do so could cause spring to fly off, resulting in injury to personnel.
8.
9.
10.
11.
REMOVE AND DISCARD SHAFT (23), SPRING (24), AND YOKE (25) FROM TOP PLATE (17).
REMOVE TWO COTTER PINS (26), PIN (27), SPRING (28), AND LOCK GUARD (29). DISCARD
COTTER PINS, PIN, AND LOCK GUARD.
REMOVE TWO COTTER PINS (30), TWO PINS (31), AND TWO LOCKS (1). DISCARD COTTER
PINS AND PINS.
IF DAMAGED, REMOVE TWO GREASE FITTINGS (32) FROM TOP PLATE (17).
Use general cleaning methods to clean all parts (page 2-30).
Inspect all parts for wear or damage.
20-17
