TM 9-2320-363-34-2
BULL/lDLER GEAR REPLACEMENT (CONT)
3.
4.
INSTALL CRANKSHAFT PROTECTOR (5) ON END OF CRANKSHAFT OVER ENGINE BARRING
TOOL (6).
REMOVE TWO LOWER BOLTS (7).
C A U T I O N
Do not allow bull/idler gear to come in contact with crankshaft oil seal contact
surface. Oil leaks may result if this surface is scratched.
Bull/idler gear
5.
GRASP BULL/IDLER GEAR (8)
6.
REMOVE TWO GUIDE STUDS
NOTE
will rotate slightly as it is being removed.
AND PULL OUT OF CYLINDER BLOCK RECESS.
(4).
12-94
