1.
2.
3.
4.
If removing rear window glass
window glass and seal, perform
TM 9-2320-363-34-1
NOTE
only, perform steps 1 thru 3. If removing rear
steps 1 thru 5.
IF REAR WINDOW GLASS (1) IS CRACKED DUE TO ANY CAUSE OTHER THAN BEING HIT BY A
FLYING OBJECT, MARK RUBBER EXTRUSION (2) AT LOCATION OF CRACK.
USING WINDSHIELD PICK, RELEASE LOCKING STRIP (3) FROM RUBBER EXTRUSION (2).
W A R N I N G
Wear protective gloves when handling glass. Failure to do so could result in
injury to personnel.
C A U T I ON
When handling glass, be careful not to nick or splinter edges Chipped edges
could cause cracking later.
APPLY PRESSURE TO ONE EDGE OF REAR WINDOW GLASS (1) FROM INSIDE CAB (4). USING
WINDSHIELD PICK, LIFT AND REMOVE REAR WINDOW GLASS (1) OUT OF RUBBER EXTRUSION (2).
REMOVE RUBBER EXTRUSION (2) FROM CAB (4).
5.
REMOVE SEALING COMPOUND FROM BETWEEN ENDS OF RUBBER EXTRUSION (2).
Use general cleaning methods to clean all parts (page 2-30).
1.
IF REAR WINDOW GLASS HAS BEEN REMOVED UNDER CRITERIA OUTLINED IN REMOVAL
STEP 1, INSPECT CHANNEL OF RUBBER EXTRUSION WHERE MARKED FOR FOREIGN
OBJECTS. INSPECT MOUNTING FLANGE OF CAB FOR IRREGULARITIES.
2.
INSPECT ALL PARTS FOR WEAR OR DAMAGE.
10-85
