TM 9-2320-363-34-1
E N G I N E R E P L A C E M E N T ( C O N T )
6.
REMOVE SCREW (23), BRACKET (24), AND SPACER (25) FROM ENGINE BLOCK (26). SET
CABLE HARNESS (27) ASIDE.
7.
8.
REMOVE NUT (28), WASHER (29), AND WIRE (30) FROM FUEL PRESSURE SENDING UNIT (31).
IF REMOVING A DDEC II EQUIPPED ENGINE, DISCONNECT TWO PLUGS (32) AND
CONNECTOR (33) FROM DDEC II ELECTRONIC CONTROL MODULE (34). PULL HARNESS (35)
OUT AND TIE TO CAB MOUNT.
8.1
IF REMOVING A DDEC III EQUIPPED ENGINE, DISCONNECT DDEC III ELECTRONIC CONTROL
MODULE HARNESS(ES) FROM CONNECTORS LOCATED AT REAR OF ECM.
8.2
CUT TIE WRAPS AS REQUIRED TO FREE HARNESS FROM ENGINE.
3-6
Change 1
