TM 9-2320-363-34-1
E Q U A L I Z I N G B E A M R E P L A C E M E N T ( C O N T )
1.
2.
3.
4.
5.
9-32 Change 1
Rotate adapters so flat side is vertical. Do not tighten adapters until both ends are installed.
INSTALL TWO NEW ADAPTERS (4), WASHER (5), SCREW (6), WASHER (7), AND NUT (8).
REPEAT STEPS 1 THRU 3 FOR REAR END OF EQUALIZING BEAM (2) IN REAR AXLE (9).
TIGHTEN TWO NUTS (8) ON BOTH ENDS OF EQUALIZING BEAM (2) TO 210-240 LB-FT (285-325
N.m).
N O T E
Procedure is the same for both sides and both ends of equalizing beam.
INSTALL INTERMEDIATE TUBE (1).
N O T E
Perform steps 2 through 5 on M916A1 only.
USING SUITABLE LIFTING DEVICE, POSITION FRONT END OF EQUALIZING BEAM (2) IN
MOUNTING BRACKET OF FORWARD-REAR AXLE (3).
N O T E
