TM 9-2320-363-34-1
7.
8.
9.
10.
11.
12.
REMOVE EIGHT NUTS (13), EIGHT WASHERS (14), AND FOUR SADDLE CAPS (15) FROM TWO
SPRING ASSEMBLIES (1).
USING BLOCK OF WOOD AND JACK STAND, SUPPORT REAR ENDS OF TWO EQUALIZING
BEAMS (16). REMOVE TWO NUTS (17), TWO WASHERS (18), TWO SCREWS (19), TWO
WASHERS (20), AND FOUR ADAPTERS (21) FROM REAR END OF TWO EQUALIZING BEAMS
(16). DISCARD ADAPTERS.
LOWER REAR ENDS OF TWO EQUALIZING BEAMS (16) ONTO BLOCKS.
REPEAT STEPS 8 AND 9 FOR FRONT END OF TWO EQUALIZING BEAMS (16).
REMOVE FOUR INTERMEDIATE TUBES (22) FROM TWO EQUALIZING BEAMS (16).
REMOVE ONE EQUALIZING BEAM (16) FROM BLOCKS AND REMOVE CROSSTUBE (23) FROM
OTHER EQUALIZING BEAM (16).
Use general cleaning methods to clean all parts (page 2-30).
9-25
