TM 9-2320-363-34-1
7.
8.
9.
10.
11.
NOTE
Note direction of indication arrow on new seal showing engine rotation.
CAREFULLY INSTALL NEW CRANKSHAFT OVERSIZE REAR OIL SEAL (7) ON NEW WEAR
SLEEVE (8) FROM CHAMFERED END OF SLEEVE. POSITION OIL SEAL (7) IN MIDDLE OF
SLEEVE (8) WITH CASE SIDEOF SEAL AWAY FROM CHAMFERED END OF SLEEVE.
POSITION AND INSTALL OIL SEALAND SLEEVE ASSEMBLY IN OIL SEAL INSTALLER HOUSING
(9) WITH SEAL CASING AGAINST INSTALLER HOUSING.
PLACE OIL SEAL INSTALLER HOUSING (9) WITH OIL SEAL AND SLEEVE ASSEMBLY OVER
CENTER SCREW (6) AND TWO GUIDE STUDS (4) AND POSITION SLEEVE (8) AGAINST REAROF
CRANKSHAFT (3).
INSTALL THRUST BEARING (10) ON CENTER SCREW (6) WITH LETTERED SIDE OF BEARING
AGAINST OIL SEAL INSTALLER HOUSING (9).
INSTALL NUT (11) ON CENTER SCREW (6). TIGHTEN NUT UNTIL CRANKSHAFT OVERSIZE REAR
OIL SEAL AND SLEEVE ARE SEATED FIRMLY.
REMOVE OIL SEAL INSTALLER NUT (11), THRUST BEARING (10), INSTALLER HOUSING (9),
SPACER (5), GUIDE STUDS (4), AND INSTALLER BASE (2).
3-147
