TM 9-2320-363-34-1
AIR COMPRESSOR DRIVE REPLACEMENT AND REPAIR (CONT)
NOTE
Make sure all old gasket material from air compressor drive assembly mounting
flange and gear housing mating area is removed.
If necessary, rotate drive gear slightly to engage gear teeth of bull gear and
fully seat pilot ring of air compressor-drive in gear-housing.
1.
POSITION NEW GASKET (1) ON FLANGE OF AIR COMPRESSOR DRIVE (2). POSITION AIR
COMPRESSOR DRIVE (2) ON GEAR HOUSING (3).
2.
INSTALL FIVE BOLTS (4). INSTALL SHORTER BOLT (5) IN 1 O’CLOCK POSITION WHEN VIEWED
FROM AIR COMPRESSOR END OF AIR COMPRESSOR DRIVE (2). TIGHTEN BOLTS TO 43-54
LB-FT (58-73 N.m).
NOTE
Follow-on Maintenance:
Install power steering pump (Page 7-2).
Install air compressor (TM 9-2320-363-20).
3-100
