STEP/SEQUENCE
RESULT
WHAT TO DO NEXT
TM 9-2320-363-20-1
Section 4
TROUBLESHOOTING CHARTS
E. VEH5V - VEHICLE HARNESS +5 VOLTS SUPPLY (CONTD)
VEHSV-10 Check ECM
Connectors
Turn Ignition off.
Terminals and
Replace ECM. Then go
Disconnect the vehicle harness
connectors are okay.
to VEH5V-30.
connector at the ECM (if not
already disconnected).
Problem found.
Repair terminals/connectors.
Check terminals at the ECM
Then go to VEH5V-30.
vehicle harness connector (both
the ECM and harness side) for
damage; bent, corroded and
unseated pins or sockets.
Especially terminals #952, #916,
#417 and #510. Install new
terminal if in doubt.
VEH5V.11
Check for Short to
Battery +
Turn ignition off.
All readings are
Go to VEH5V-10.
Pull both fuses (or circuit breakers)
greater than 10,000
to the ECM.
ohms or open.
Disconnect the vehicle harness
and 5-way power harness
Any reading is
A short exists between the engine
connectors at the ECM.
less than 10,000 ohms.
+5 volt line (ckt #916) and the
Read resistance between sockets
line(s) where less than 10,000
A3 and B3 on the vehicle harness
ohms was read (either: ckt #240,
connector.
#241 or #439). Repair short.
Also read resistance between
Then go to VEH5V-30.
socket A3 on the vehicle harness
connector and the following
sockets on the 5-way power
harness connector: A and C.
VEH5V-12 Open Check
Connect TPS
Both 4.7 to
Repair open from ckt #952 to
Turn ignition on.
5.2 volts.
ECM. (Look at ECM terminal)
Read voltage on PTOSA harness
Repair open, then go to
connector, socket C (red lead)
VEH5V-30.
and a good battery ground
Repeat above only place red lead
Pin C greater
Go to VEH5V-7.
is socket A of the PTOSA
than 4.7 volts and
connector.
Pin A is zero volts.
Change 3 3-345.425