STEP/SEQUENCE
RESULT
WHAT TO DO NEXT
TM 9-2320-363-20-1
Section 4
TROUBLESHOOTING CHARTS
E.
FLASH CODE:
81 - CRANKCASE MONITOR (CCM) SIGNAL VOLTAGE HIGH (CONTD)
J1587 CODE:
P98 3 - OIL LEVEL CIRCUIT FAILED HIGH
P101 3 - CRANKCASE PRESSURE CIRCUIT FAILED HIGH
81.5
Check for Short
Turn ignition off.
Less than or
Signal line (ckt #906) is shorted
Disconnect engine harness
equal to 10,000 ohms.
to engine +5 Volt line (ckt
connector at the ECM.
#416).
Repair short. Then go to
Read resistance between sockets
81-30.
W1 and N1 on engine harness
connector.
Greater than
Go to 81-6.
10,000 ohms or open.
81-6
Check for Short to
Battery +
Remove both fuses to ECM.
All readings are
Go to 81-8.
Disconnect vehicle harness
greater than 10,000 ohms
and 5-way power harness
or open.
connectors at ECM.
Read resistance between sockets
Any reading is
A short exists between sockets
N1 of engine harness connector
less than or equal to
where less than 10,000 ohms
and socket B3 of vehicle
10,000 ohms.
resistance was read. Repair
harness connector.
short and reinsert fuses ( or
Also read resistance between
reset breakers). Then go to
socket N1 on engine harness
81-30.
connector and the following
sockets on the 5-way power
harness connector: A, and C.
81-7
Final Check
Reconnect all connectors.
Code 98-101/3.
Replace ECM. Then go to 81-30.
Turn ignition on.
Clear codes.
No codes.
Repairs are complete.
Start engine. Run for 1 minute
or until "Check Engine" light
Any other codes
Go to START-1, pg 3-345.41,
comes on.
except Code 98-101/3.
to service other codes.
Stop engine.
Clear ACTIVE CODES
81.8
Check CCM Connectors
Inspect terminals at CCM
Terminals and
Replace CCM. Then go to 81-7.
connectors (sensor side and
connectors are okay.
harness side) for damage; bent,
corroded, and unseated pins or
Problem found
Repair terminals/connectors.
sockets
Then go to 81-30.
Change 3 3-345.379
