STEP/SEQUENCE
RESULT
WHAT TO DO NEXT
TM 9-2320-363-20-1
Section 4
TROUBLESHOOTING CHARTS
E. FLASH CODE: 35
J1587 CODE: P100 3- OIL PRESSURE CIRCUIT FAILED HIGH (HIGH VOLTAGE)
35-7 Final Check
Reconnect all connectors.
Code 100/3.
Reprogram ECM. Then go to
Turn ignition on.
35-30.
Clear codes.
No codes.
Repairs are complete.
Start engine. Run for one
or until "Check Engine"
Any other codes .
Go to START-1, pg 3-345.41,
light comes on.
except Code 100/3.
to service other codes.
Stop engine.
Check active codes.
35-8 Verify Repairs
Inspect terminals at OPS
Terminals and
Replace OPS. Then go to 35-
7.
connectors (sensor and harness
connectors are okay.
sides) for damage; bent, corroded
and unseated pins or sockets.
Problem found.
Repair terminals/connectors.
Then go to 35-30.
35-30 Verify Repairs
Turn ignition off.
(No codes).
Repairs are complete.
Reconnect all connectors.
Turn ignition on.
Code 100/3 (and
All system diagnostics are
Clear codes.
any other codes).
complete. Please review this
Note status of "Check Engine"
section from the start to find
light.
the error.
If "Check Engine" light does not
stay on, start engine and run until
Any other codes
Go to START-1, pg 3-345.41,
"Check Engine" light comes on
except Code 100/3
to service other codes.
or engine has run warm (greater
than 60 degrees C, 140 degrees
F) 1 minute.
Read inactive codes.
Change 3 3-345.287
